Orlene Flooring July 30th, 2017 - 17:37:32
Dust, grit and moisture are gifts of nature and we all have to deal with them. Grit which stems from sand or dirt being tracked from the outdoors on the surface works like sandpaper on the floor finish. Dust mites, balls and the like are merely pulverized bits of dirt which in essence acts in the same way as grit over the long haul on your floors. Once your floor finish gets damaged grit and dust left on the surface tend to discolor the hardwood while being ground into the surface pores with each step made on top of it like a hammer pounding stroke after stroke.
Did you see a picture that you like and now you have the bug that you want that special floor? The good news is that it could probably be made for you, but before you go a long ways down the path of choosing which floor you want and requesting a display room full of samples, ask about some price ranges. There is a common misconception that since reclaimed wood is supposedly salvaged it should be cheaper than virgin wood floors. If you are buying a quality kiln dried and precision milled product, generally that is not the case. The only cost savings would be if you found some scraps or did some salvage work yourself, you might save some costs. For example you might find a gym floor or planks out of a barn hay loft that you want to nail down on your floor. The material might have been next to free, but how much time are you going to have in making it usable and pulling nails? Are the results what you want?
However if you go for a quality engineered wood flooring you can even gone as far as to boil a piece of our floor for 30 minutes and the board still will not de-laminate. The 15mm ply wood under core is what gives the flooring the strength and stability is has. Oak is a natural product and when used for flooring the board widths can change in size. This can cause gaps between boards or the floor to buckle and this movement is most commonly caused by the changing of humidity in the environment. Because of the stability of a quality engineered oak floor it is far less prone to this movement. This stability is also becoming of greater importance today due to the fact that an increasing number of properties are having under floor heating systems installed, which of course causes a frequent change in humidity. Having said this I would again like to reiterate that I am writing in regards to a quality, higher spec engineered oak flooring, and I can not talk for all engineered wood floors.
In this article we will be discussing several different categories of wood flooring. Solid wood flooring is one board with no glued up laminations; it is basically wood board that has been sized and profiled to a certain dimension. Engineered flooring has a on the top whatever species and texture you want, and this is glued to a plywood backer on the bottom. Engineered is still all wood but is made with multiple layers that are laminated for better stability and dimensional accuracy. Floors that we will not cover here are laminates or any composite products which are often not wood entirely through the plank or may be made with a photo printed surface. We also will not cover vinyl, carpet, stone, or tile.