Belda Flooring August 13th, 2017 - 20:26:16
Here is a word on prefinished product if they factor into your decision. If you come up short on your order, the next lot that you buy may not match your previous batch. This is especially a problem on the lower end price floors and import floors. Good luck trying to blend it in with your previous floor. So if you go this route, be extra accurate on your measurements. Right now the rage is lifetime warranties on flooring. We stop to think is that really even possible? First will that importer or manufacturer really be around a lifetime? A lot of products are made oversees; the warranty is only good if there is somebody still around for the life of the warranty.
Working in the flooring industry we often have customers calling us because they are interested in a solid oak floor. More often than not we end up suggesting they go down the engineered route and then being asked the same thing, `why choose an engineered wood floor over a solid oak floor and does it really feel and look as beautiful?` We are writing this article to briefly outline the main advantages of our engineered wood flooring and why now so many people are choosing the engineered over the traditional solid oak flooring. Throughout this article I will write in reference to a top quality engineered oak flooring with multiple layers of ply wood under core and a thick, long lasting wear layer. I can not speak on behalf of all engineered wood floors as they differ massively in quality and price. In all cases you need to check thoroughly the specifications of the product on offer.
All joists must extend at least 1-1/2" on to a bearing assembly, of either a beam or full height wall, unless metal hangers are installed to provide proper bearing support against other structural components. Beams, which support the floor joists over greater spans, are constructed in the form of laminated joists often referred to as built up beams, or one piece solid load bearing beams, cut from logs or manufactured. Electricians and plumber may often cut or drill into the joist work to install utilities, and this is accepted, so long as they do not remove more material than what is required by codes. This type of floor system is usually the cheapest to install.
However if you go for a quality engineered wood flooring you can even gone as far as to boil a piece of our floor for 30 minutes and the board still will not de-laminate. The 15mm ply wood under core is what gives the flooring the strength and stability is has. Oak is a natural product and when used for flooring the board widths can change in size. This can cause gaps between boards or the floor to buckle and this movement is most commonly caused by the changing of humidity in the environment. Because of the stability of a quality engineered oak floor it is far less prone to this movement. This stability is also becoming of greater importance today due to the fact that an increasing number of properties are having under floor heating systems installed, which of course causes a frequent change in humidity. Having said this I would again like to reiterate that I am writing in regards to a quality, higher spec engineered oak flooring, and I can not talk for all engineered wood floors.