Orlene Flooring July 14th, 2017 - 22:41:10
Carpet is probably the most common floor covering that is used in residential homes. It comes in a wide variety of colors and textures. Carpet consists of woven fibers, which protrude upwards, glued or woven into a foam or jute backing. Often an underpad of pressed foam is installed below it or the backing can be integral with the carpet, adding to the softness and providing a much more comfortable surface for walking on. Carpet is installed by either gluing the carpet to the sub-floor, or the use of carpet tack around the perimeter. A good carpet will has a close weave, which will not show the backing material when separated. To reduce project costs, some contractors will opt to install a high quality underlay, with a low or medium quality carpet. This provides the soft surface, with equal durability, giving the homeowner the benefits of high quality carpet, at a reduced cost.
Dust, grit and moisture are gifts of nature and we all have to deal with them. Grit which stems from sand or dirt being tracked from the outdoors on the surface works like sandpaper on the floor finish. Dust mites, balls and the like are merely pulverized bits of dirt which in essence acts in the same way as grit over the long haul on your floors. Once your floor finish gets damaged grit and dust left on the surface tend to discolor the hardwood while being ground into the surface pores with each step made on top of it like a hammer pounding stroke after stroke.
In a reclaimed product the engineered flooring really shines. Since the nature of reclaimed material is rustic with splits, various height, warps and so forth by doing an engineered product we can eliminate those issues. We match the texture and color that you want in the floor but you don`t have to put up with the inherent problems that come with installing and living with a reclaimed wood floor. A number of solid wood reclaimed floors have warped and twisted boards, gaps between rows, height difference between rows, holes, and other "nostalgia and romance" that may become unwelcome after living with the floor for a while. Due to our precise sanding during the lamination process for the engineered product and after, pieces are more consistent in height, more uniform in texture, fit together tighter, no waste, holes and cracks already filled, and no sanding necessary after install unless you want to do a light screen or buff.
In the case of long span truss work, bearing lengths of at least 3" are quite common. Trusses span greater distances than framed floor assemblies and can be designed to span the entire building, eliminating center load bearing supports. They are moderately more expensive than framed floor assemblies, but provide a remarkably strong floor with little deflection or "bounce" to it. Another advantage to this type of structural system, is that utility installations can be run between the webwork components. Never allow trades to cut or drill into the members of a truss, for they are manufactured precisely for the loading conditions they will undergo during the life of the building.