Solaina Flooring July 12th, 2017 - 18:53:41
Working in the flooring industry we often have customers calling us because they are interested in a solid oak floor. More often than not we end up suggesting they go down the engineered route and then being asked the same thing, `why choose an engineered wood floor over a solid oak floor and does it really feel and look as beautiful?` We are writing this article to briefly outline the main advantages of our engineered wood flooring and why now so many people are choosing the engineered over the traditional solid oak flooring. Throughout this article I will write in reference to a top quality engineered oak flooring with multiple layers of ply wood under core and a thick, long lasting wear layer. I can not speak on behalf of all engineered wood floors as they differ massively in quality and price. In all cases you need to check thoroughly the specifications of the product on offer.
Strip floors, were once the most popular type of sub-floor installed. But with the introduction of manufactured sheathing products, it has become less utilized. Strip floors consist of 1" by 6" or 8" boards, placed diagonally over the floor joist framing system. It is slightly more expensive to install, and requires experienced tradesmen. To install such floors properly, the lumber should be non-kiln dried, with a relatively high moisture content. This may seem odd, but in reality, as the wood dries out, it will shrink.
Here is a word on prefinished product if they factor into your decision. If you come up short on your order, the next lot that you buy may not match your previous batch. This is especially a problem on the lower end price floors and import floors. Good luck trying to blend it in with your previous floor. So if you go this route, be extra accurate on your measurements. Right now the rage is lifetime warranties on flooring. We stop to think is that really even possible? First will that importer or manufacturer really be around a lifetime? A lot of products are made oversees; the warranty is only good if there is somebody still around for the life of the warranty.
Raw sheathing comes in 4`x8` sheets, most often installed as 3/4" thick plywood panels. This type of sheathing is adequate for spanning joist work spaced up to 24" apart. The sheathing is lain with the joints staggered in such a matter, that no two edge joints line up with adjoining sheets. It is very easy to install, requiring the least amount of labour. The sheets are fastened with either 1-1/2" flooring screws, or 2-1/2" nails, spaced about 8" apart. Although not required, it is a good idea to provide backers or supports under the joints, between sheets which run perpendicular to the framed floor assembly.