Orlene Flooring July 15th, 2017 - 18:25:53
However if you go for a quality engineered wood flooring you can even gone as far as to boil a piece of our floor for 30 minutes and the board still will not de-laminate. The 15mm ply wood under core is what gives the flooring the strength and stability is has. Oak is a natural product and when used for flooring the board widths can change in size. This can cause gaps between boards or the floor to buckle and this movement is most commonly caused by the changing of humidity in the environment. Because of the stability of a quality engineered oak floor it is far less prone to this movement. This stability is also becoming of greater importance today due to the fact that an increasing number of properties are having under floor heating systems installed, which of course causes a frequent change in humidity. Having said this I would again like to reiterate that I am writing in regards to a quality, higher spec engineered oak flooring, and I can not talk for all engineered wood floors.
Fifth, compare overall thickness and the height from the top of the tongue or nail groove to the top of the face on the floor. On an engineered floor this is generally the thickness of a wear layer. Most solid wood floors are 3/4" overall before sanding (but some are less) with 1/4" above the nail groove. Our engineered floor is manufactured to equivalent measurements but most engineered floors have a thinner wear layer. This comes down to how many times the floor can be sanded. What kind of finish and texture you want on the floor factors into how deep you will re-sand the floor during refinishing. A number of our reclaimed wood floors are sold with an original texture that shows the old saw marks and character in the floor, so most likely you won`t want to sand this out. As a rule of thumb, the thicker the wear layer then the longer the floor will last.
In the case of long span truss work, bearing lengths of at least 3" are quite common. Trusses span greater distances than framed floor assemblies and can be designed to span the entire building, eliminating center load bearing supports. They are moderately more expensive than framed floor assemblies, but provide a remarkably strong floor with little deflection or "bounce" to it. Another advantage to this type of structural system, is that utility installations can be run between the webwork components. Never allow trades to cut or drill into the members of a truss, for they are manufactured precisely for the loading conditions they will undergo during the life of the building.
In this article we will be discussing several different categories of wood flooring. Solid wood flooring is one board with no glued up laminations; it is basically wood board that has been sized and profiled to a certain dimension. Engineered flooring has a on the top whatever species and texture you want, and this is glued to a plywood backer on the bottom. Engineered is still all wood but is made with multiple layers that are laminated for better stability and dimensional accuracy. Floors that we will not cover here are laminates or any composite products which are often not wood entirely through the plank or may be made with a photo printed surface. We also will not cover vinyl, carpet, stone, or tile.