Lundy Flooring August 02nd, 2017 - 16:41:02
Some think of interlocking tiles and immediately think of ugly, heavy, rubber flooring used in the industrial sector. This could not be further from the truth. While interlocking tiles were initially created to serve the industrial sector, they have come a long way since that time. Interlocking floor tiles are now available in an array of finishes and material types. They can be purchased in rubber, plastic, vinyl and porcelain, among many other high quality materials. Virtually any tile material that can be used in a traditional installation can also be used in interlocking floor tiles.
In the case of long span truss work, bearing lengths of at least 3" are quite common. Trusses span greater distances than framed floor assemblies and can be designed to span the entire building, eliminating center load bearing supports. They are moderately more expensive than framed floor assemblies, but provide a remarkably strong floor with little deflection or "bounce" to it. Another advantage to this type of structural system, is that utility installations can be run between the webwork components. Never allow trades to cut or drill into the members of a truss, for they are manufactured precisely for the loading conditions they will undergo during the life of the building.
You can choose furniture coasters from a vast array of styles at most any hardware, home improvement or house ware shop. Styles and techniques range from special materials that are circular, oval, and rectangular or square which peel and stick to smooth surfaces with special materials attached to metal frames which can be used in your wooden floor surface`s care by hammering them into the legs` bottoms of furniture. An alternative would be to make furniture coasters for your hardwood floors and wooden floors` care. Coasters can also be used to protect the tops of wood furniture against circles which form from glasses or cups containing liquids.
Raw sheathing comes in 4`x8` sheets, most often installed as 3/4" thick plywood panels. This type of sheathing is adequate for spanning joist work spaced up to 24" apart. The sheathing is lain with the joints staggered in such a matter, that no two edge joints line up with adjoining sheets. It is very easy to install, requiring the least amount of labour. The sheets are fastened with either 1-1/2" flooring screws, or 2-1/2" nails, spaced about 8" apart. Although not required, it is a good idea to provide backers or supports under the joints, between sheets which run perpendicular to the framed floor assembly.