Orlene Flooring July 15th, 2017 - 18:53:23
Interlocking floor tiles are also useful to those who might only want to make a temporary change to their floors. Traditional tiles require adhesive and caulking, which frequently results in damage to the underlying floor. Interlocking tiles do not usually require any adhesive at all and can be pulled up as needed. This allows for more versatility should the user decide to change their floor back or install a different set of interlocking floor tiles.
The third variable is installation costs. Our engineered product has labor savings over our solid wood product because it is pre-sanded and milled to tighter tolerances. It is also prefilled in the holes and has next to zero waste. On the other hand you may have a little more in cost of gluing it down in addition to nails, but this is just a step in direction of better quality and peace of mind during the install.
We personally do not care for prefinished flooring due to installation problems associated with it, so our product requires site applied finish. This means that your floor finish if site applied will be easier to sand and refinish than a prefinished floor. Also you do not have to deal with that micro bevel groove between each board that tends to fill up with dust and crumbs. Most prefinished hardwood floors really can`t be refinished easily. To sand it off means that the wear layer has to be thicker than the height of the nails and have room to sand off the micro bevel between boards; that amounts to a lot of sanding. You also will not be able to spot sand or touch up parts of the floor.
Dust, grit and moisture are gifts of nature and we all have to deal with them. Grit which stems from sand or dirt being tracked from the outdoors on the surface works like sandpaper on the floor finish. Dust mites, balls and the like are merely pulverized bits of dirt which in essence acts in the same way as grit over the long haul on your floors. Once your floor finish gets damaged grit and dust left on the surface tend to discolor the hardwood while being ground into the surface pores with each step made on top of it like a hammer pounding stroke after stroke.