Orlene Flooring July 15th, 2017 - 18:43:58
Truss floors are simply that. They are constructed from small dimensioned lumber, interconnected in a webwork pattern by the use of metal or wood plates. Occasionally, the trusses will be built on site, utilizing plywood plates to connect the webwork together. Generally they are installed 24" apart, either suspended on bearing walls or beams, or installed with plywood trim or rim joists around the perimeter. Strapping is installed on the bottom side, to prevent turning in place, which is a common ailment for deep truss components.
Of all the wood flooring, the most often installed is the parquet tile. They consist of square interlocking wood strips, held together with glues and/or metal wires. Often they come as single 6"x6", or multiple 12"x12" square tiles, about 1/4" thick. They are glued directly to the sub-flooring, and are strong enough to span small deviations in it. The wood is often prefinished, and requires little maintenance. Parquet floors are a cheaper alternative to strip flooring, providing the same warm, durable surface.
Wood strip flooring is one of the oldest types of flooring still popular in the modern age. It consists of wood strips, usually interlocking, which are either nailed or glued to the sub-floor. Often the strips will be prefinished, requiring no post applications of sealers or varnishes. This type of flooring is very labour intensive for installation, as well as being quite expensive to purchase. However, the results are a warm, durable floor surface, requiring little maintenance or upkeep. Wood strip flooring significantly adds to the strength of the support system, reducing the deflection ("bounce") and gives the floor a very solid feel to it.
For the second variable here is a controversial opinion: we do not end match our flooring which means there is no tongue and groove on the ends of the planks. Since we recommend our floor be glued down we say this is an unnecessary expense for the customer. End matching reduces the yield in production and raises labor costs. Most end match profiles are milled so loosely that they really don`t hold the floor in place anyway. The biggest benefit to the installer is that the plank can be cut in half in any place and reused anywhere without have to mate up to a complementary tongue or groove since the end is just square cut. This means all end trim pieces or any waste can be reused. Therefore on our engineered flooring product the waste factor is virtually nothing unless there are angles or radiuses to work around. We also help with waste factor by usually supplying a random width product so when one gets close to the end of a room they can plan the width combination patterns out to not have to rip much off the last row.