Orlene Flooring July 15th, 2017 - 19:24:41
One drawback is that this type of floor requires special hanger systems designed for the joists, to enable them to be hung from each other or against beams/bearing walls. Manufactured joists are becoming a popular flooring system, for they are relatively cheap, reduce labour time and provide adequate support. However, builders need to familiarize themselves with its installations, for poor installation can cause severe structural damage to the joists. A good example is a three point, center bearing joist, left with the top chord uncut, which can potentially fail or pull apart, over the center bearing point.
Interlocking floor tiles are also useful to those who might only want to make a temporary change to their floors. Traditional tiles require adhesive and caulking, which frequently results in damage to the underlying floor. Interlocking tiles do not usually require any adhesive at all and can be pulled up as needed. This allows for more versatility should the user decide to change their floor back or install a different set of interlocking floor tiles.
Seventh, are you a do-it-yourselfer? Think through every step of the process to be sure that you can do it yourself. Usually the install can be done with relatively moderate skills and simple tools like a chop saw and rented flooring nailer. The finishing process is a whole different matter. The sanders and buffers take some special skills to operate. A normal price range for labor and materials to install a wood floor is $4-5 per square foot. It is possible to build your own sweat equity into a floor install. Maybe this is where you choose to use our engineered product for example because it is presanded to more accurate tolerances than a solid wood product. It can be touched up with a hand held orbital sander rather than industrial floor sanders. Then if you are doing the finish yourself, you will want to consider using a finish that may not require as much buffing between coats.
The third variable is installation costs. Our engineered product has labor savings over our solid wood product because it is pre-sanded and milled to tighter tolerances. It is also prefilled in the holes and has next to zero waste. On the other hand you may have a little more in cost of gluing it down in addition to nails, but this is just a step in direction of better quality and peace of mind during the install.