Aveline Flooring July 16th, 2017 - 21:28:39
Another good flooring for wet areas is the vinyl tile. Typically it is manufactured in much the same way as sheet vinyl, but is much more rigid and comes as 12"x12" square units. They are installed in the much the same way, but require skilled tradesmen, familiar with proper installation. A good installer will start from the middle of the room to ensure that all cut tiles are equal in width at opposing walls. One advantage to this type of flooring, over sheet vinyl, is that it is can be installed, without danger of joint separation, over large areas. For this reason, it is often used in commercial buildings where large rooms are the norm. Vinyl tile can also be easily installed directly to concrete floors. Like vinyl sheets, it too is resistant to water, and tends to be installed in the areas of a building, prone to water accumulations. Tile, can be easily cleaned, is relatively maintenance free, and one of the cheaper finished floors to install.
Truss floors are simply that. They are constructed from small dimensioned lumber, interconnected in a webwork pattern by the use of metal or wood plates. Occasionally, the trusses will be built on site, utilizing plywood plates to connect the webwork together. Generally they are installed 24" apart, either suspended on bearing walls or beams, or installed with plywood trim or rim joists around the perimeter. Strapping is installed on the bottom side, to prevent turning in place, which is a common ailment for deep truss components.
All joists must extend at least 1-1/2" on to a bearing assembly, of either a beam or full height wall, unless metal hangers are installed to provide proper bearing support against other structural components. Beams, which support the floor joists over greater spans, are constructed in the form of laminated joists often referred to as built up beams, or one piece solid load bearing beams, cut from logs or manufactured. Electricians and plumber may often cut or drill into the joist work to install utilities, and this is accepted, so long as they do not remove more material than what is required by codes. This type of floor system is usually the cheapest to install.
Raw sheathing comes in 4`x8` sheets, most often installed as 3/4" thick plywood panels. This type of sheathing is adequate for spanning joist work spaced up to 24" apart. The sheathing is lain with the joints staggered in such a matter, that no two edge joints line up with adjoining sheets. It is very easy to install, requiring the least amount of labour. The sheets are fastened with either 1-1/2" flooring screws, or 2-1/2" nails, spaced about 8" apart. Although not required, it is a good idea to provide backers or supports under the joints, between sheets which run perpendicular to the framed floor assembly.