Belda Flooring August 10th, 2017 - 17:52:59
Ceramic tile is probably the most durable types of flooring and is typically installed in entry areas, where sand scuffing and water accumulations are the norm. Bathrooms and kitchens often get this type of floor treatment as well, but due to the high cost of installation, homeowners tend to not include these areas. Ceramic tile are typically a square tile, although interlocking units are on the market, in standard square measurements of 4", 6",8" or 12". They are installed by one of two primary methods, either set into a thin mortar bed (called "thinset adhesive"), which also acts like glue, or a heavyset bed of 1-1/2" normal mortar base. For all ceramic tile installations, the floor must be built up to ensure the strength required to prevent tile or joint cracking. Often, installers put down a material called "cement board", which is much like drywall, but is made of glass fibers and cement. In any case, ensure that your installer will offer you a guarantee against future cracking or uplift of tiles. Ceramic tiles require little maintenance, but beware, water on glossy floor tiles can be very slippery, and many a time, a homeowner has resented the installation of a high gloss tile, over a bathroom floor area.
So, a top quality oak engineered flooring will look the same but will it actually last as long?. How long a floor will last is mostly down to something called its `wear layer`. The part of the floor that is classed as the wear layer is from the surface of the board down to the tongue and on a solid oak board this would be around 5-6mm. Now, the wear layer on engineered wood flooring is the top layer of oak. So if you purchase an engineered oak flooring which has a 5-6mm solid oak top layer it will result in the flooring lasting just as long. In conclusion if you want an engineered flooring that is going to last as long as a traditional solid oak floor then make sure it has a nice thick top layer of wood, ideally 5mm+.
Fifth, compare overall thickness and the height from the top of the tongue or nail groove to the top of the face on the floor. On an engineered floor this is generally the thickness of a wear layer. Most solid wood floors are 3/4" overall before sanding (but some are less) with 1/4" above the nail groove. Our engineered floor is manufactured to equivalent measurements but most engineered floors have a thinner wear layer. This comes down to how many times the floor can be sanded. What kind of finish and texture you want on the floor factors into how deep you will re-sand the floor during refinishing. A number of our reclaimed wood floors are sold with an original texture that shows the old saw marks and character in the floor, so most likely you won`t want to sand this out. As a rule of thumb, the thicker the wear layer then the longer the floor will last.
Undoubtedly you`ve seen wood floors where it seems that the edges or seams of boards joined together curl up or the width of a board creates a bow like upward arc in the middle. These are indications of moisture damage to a wooden floor. For example, there have even been instances where moisture damage caused floor boards to arc together to raise a full length sofa about three feet into the air. That was merely from the curl effect and strength of water on wooden floor boards. So, by all means do dry any spills to keep moisture and liquids away from your wooden floors.