Solaina Flooring August 07th, 2017 - 18:20:49
Another good flooring for wet areas is the vinyl tile. Typically it is manufactured in much the same way as sheet vinyl, but is much more rigid and comes as 12"x12" square units. They are installed in the much the same way, but require skilled tradesmen, familiar with proper installation. A good installer will start from the middle of the room to ensure that all cut tiles are equal in width at opposing walls. One advantage to this type of flooring, over sheet vinyl, is that it is can be installed, without danger of joint separation, over large areas. For this reason, it is often used in commercial buildings where large rooms are the norm. Vinyl tile can also be easily installed directly to concrete floors. Like vinyl sheets, it too is resistant to water, and tends to be installed in the areas of a building, prone to water accumulations. Tile, can be easily cleaned, is relatively maintenance free, and one of the cheaper finished floors to install.
I encourage you being cautious about potential discoloring of the wood floor in direct proportion to the shape of the center rug piece over time. Discoloration will occur not as a result of the throw rug or center rug piece but as a result of sunlight beaming on the wooden floor in areas around the center rug piece. You see, underneath the center rug piece sunlight cannot get to the wood. So, the color of your wooden floor beneath the center rug piece would be lighter in color over time than the exposed areas. I recommend you use throw/scatter rugs instead of center piece or area rugs as these would be more readily removed, freshened or relocated to minimize a lengthy tenure in one location.
Most popularly used in bathrooms, kitchens, laundry areas and entryways are vinyl sheet, or linoleum floorings. This type of flooring cones in a vast array of colors, textures and patterns, in sheet sizes of 12 foot widths with varying lengths, and made from a vinyl composite, covered with a surface coating. It is installed by applying covering over the sub-floor, usually mahogany or particle core sheets 4`x4` in size, to which the vinyl is glued to. It can also be installed directly onto concrete floors, in areas such as basements. Joining two sheets together is a standard practice when the room width exceeds 12`, or under doorways. Sheet vinyl is a good flooring in areas where water tends to accumulate, like around bathroom fixtures or at entry ways. It is fairly durable, and often maintenance free. Linoleum is one of the cheapest types of flooring to install.
Of all, the most commonly installed flooring system are framed floors. They consist of dimensioned lumber, bearing on exterior and interior load bearing walls or beams called "floor joists". Generally the floor joists are installed, spaced 16" apart. Installing rim and trimmer joists, to which the floor joists are nailed, finishes the perimeter. Bracing, usually in the form of bridging, but often installed as strapping, prevents the joists from turning in place. One other method used to prevent this type of turning is to glue the sub-flooring to the joists, as the sub-floor is placed.