Orlene Flooring August 02nd, 2017 - 15:05:57
Another good flooring for wet areas is the vinyl tile. Typically it is manufactured in much the same way as sheet vinyl, but is much more rigid and comes as 12"x12" square units. They are installed in the much the same way, but require skilled tradesmen, familiar with proper installation. A good installer will start from the middle of the room to ensure that all cut tiles are equal in width at opposing walls. One advantage to this type of flooring, over sheet vinyl, is that it is can be installed, without danger of joint separation, over large areas. For this reason, it is often used in commercial buildings where large rooms are the norm. Vinyl tile can also be easily installed directly to concrete floors. Like vinyl sheets, it too is resistant to water, and tends to be installed in the areas of a building, prone to water accumulations. Tile, can be easily cleaned, is relatively maintenance free, and one of the cheaper finished floors to install.
Installing interlocking floor tiles is a much easier and user friendly process. They are designed to clip together, eliminating the need for measuring spaces and also leaving room for the tiles to settle. Each tile is surrounded with divots that lock to the other interlocking floor tiles. They clip together easily, much like a jigsaw puzzle, and allow a perfect seamless finish. If a mistake is made while installing the interlocking tiles, it is easy to fix. Simply pull them apart and start over. As no adhesive is generally used, they do not need to be pried up, risking damage to the floor.
Strip floors, were once the most popular type of sub-floor installed. But with the introduction of manufactured sheathing products, it has become less utilized. Strip floors consist of 1" by 6" or 8" boards, placed diagonally over the floor joist framing system. It is slightly more expensive to install, and requires experienced tradesmen. To install such floors properly, the lumber should be non-kiln dried, with a relatively high moisture content. This may seem odd, but in reality, as the wood dries out, it will shrink.
Here is a word on prefinished product if they factor into your decision. If you come up short on your order, the next lot that you buy may not match your previous batch. This is especially a problem on the lower end price floors and import floors. Good luck trying to blend it in with your previous floor. So if you go this route, be extra accurate on your measurements. Right now the rage is lifetime warranties on flooring. We stop to think is that really even possible? First will that importer or manufacturer really be around a lifetime? A lot of products are made oversees; the warranty is only good if there is somebody still around for the life of the warranty.