Lundy Flooring July 15th, 2017 - 19:05:47
Strip floors, were once the most popular type of sub-floor installed. But with the introduction of manufactured sheathing products, it has become less utilized. Strip floors consist of 1" by 6" or 8" boards, placed diagonally over the floor joist framing system. It is slightly more expensive to install, and requires experienced tradesmen. To install such floors properly, the lumber should be non-kiln dried, with a relatively high moisture content. This may seem odd, but in reality, as the wood dries out, it will shrink.
I encourage you being cautious about potential discoloring of the wood floor in direct proportion to the shape of the center rug piece over time. Discoloration will occur not as a result of the throw rug or center rug piece but as a result of sunlight beaming on the wooden floor in areas around the center rug piece. You see, underneath the center rug piece sunlight cannot get to the wood. So, the color of your wooden floor beneath the center rug piece would be lighter in color over time than the exposed areas. I recommend you use throw/scatter rugs instead of center piece or area rugs as these would be more readily removed, freshened or relocated to minimize a lengthy tenure in one location.
We personally do not care for prefinished flooring due to installation problems associated with it, so our product requires site applied finish. This means that your floor finish if site applied will be easier to sand and refinish than a prefinished floor. Also you do not have to deal with that micro bevel groove between each board that tends to fill up with dust and crumbs. Most prefinished hardwood floors really can`t be refinished easily. To sand it off means that the wear layer has to be thicker than the height of the nails and have room to sand off the micro bevel between boards; that amounts to a lot of sanding. You also will not be able to spot sand or touch up parts of the floor.
Ceramic tile is probably the most durable types of flooring and is typically installed in entry areas, where sand scuffing and water accumulations are the norm. Bathrooms and kitchens often get this type of floor treatment as well, but due to the high cost of installation, homeowners tend to not include these areas. Ceramic tile are typically a square tile, although interlocking units are on the market, in standard square measurements of 4", 6",8" or 12". They are installed by one of two primary methods, either set into a thin mortar bed (called "thinset adhesive"), which also acts like glue, or a heavyset bed of 1-1/2" normal mortar base. For all ceramic tile installations, the floor must be built up to ensure the strength required to prevent tile or joint cracking. Often, installers put down a material called "cement board", which is much like drywall, but is made of glass fibers and cement. In any case, ensure that your installer will offer you a guarantee against future cracking or uplift of tiles. Ceramic tiles require little maintenance, but beware, water on glossy floor tiles can be very slippery, and many a time, a homeowner has resented the installation of a high gloss tile, over a bathroom floor area.