Calantha Flooring July 25th, 2017 - 21:10:05
I encourage you being cautious about potential discoloring of the wood floor in direct proportion to the shape of the center rug piece over time. Discoloration will occur not as a result of the throw rug or center rug piece but as a result of sunlight beaming on the wooden floor in areas around the center rug piece. You see, underneath the center rug piece sunlight cannot get to the wood. So, the color of your wooden floor beneath the center rug piece would be lighter in color over time than the exposed areas. I recommend you use throw/scatter rugs instead of center piece or area rugs as these would be more readily removed, freshened or relocated to minimize a lengthy tenure in one location.
Another way to prevent undue and excessive wear on your hardwood floors or wooden floors is to use scatter or throw rugs in high traffic areas. You may even be tempted to use a center rug piece for decor. Now that you and I have gotten past the fun stair rail slide and onto the floor, it is utterly important that we stay clear of injury -- Ensure that your throw, scatter or centerpiece rug either has sufficient non-skid backing or that you lay a non-slip material between it and your wood floor.
Ceramic tile is probably the most durable types of flooring and is typically installed in entry areas, where sand scuffing and water accumulations are the norm. Bathrooms and kitchens often get this type of floor treatment as well, but due to the high cost of installation, homeowners tend to not include these areas. Ceramic tile are typically a square tile, although interlocking units are on the market, in standard square measurements of 4", 6",8" or 12". They are installed by one of two primary methods, either set into a thin mortar bed (called "thinset adhesive"), which also acts like glue, or a heavyset bed of 1-1/2" normal mortar base. For all ceramic tile installations, the floor must be built up to ensure the strength required to prevent tile or joint cracking. Often, installers put down a material called "cement board", which is much like drywall, but is made of glass fibers and cement. In any case, ensure that your installer will offer you a guarantee against future cracking or uplift of tiles. Ceramic tiles require little maintenance, but beware, water on glossy floor tiles can be very slippery, and many a time, a homeowner has resented the installation of a high gloss tile, over a bathroom floor area.
In the case of long span truss work, bearing lengths of at least 3" are quite common. Trusses span greater distances than framed floor assemblies and can be designed to span the entire building, eliminating center load bearing supports. They are moderately more expensive than framed floor assemblies, but provide a remarkably strong floor with little deflection or "bounce" to it. Another advantage to this type of structural system, is that utility installations can be run between the webwork components. Never allow trades to cut or drill into the members of a truss, for they are manufactured precisely for the loading conditions they will undergo during the life of the building.