Nynette Flooring July 19th, 2017 - 19:59:24
All joists must extend at least 1-1/2" on to a bearing assembly, of either a beam or full height wall, unless metal hangers are installed to provide proper bearing support against other structural components. Beams, which support the floor joists over greater spans, are constructed in the form of laminated joists often referred to as built up beams, or one piece solid load bearing beams, cut from logs or manufactured. Electricians and plumber may often cut or drill into the joist work to install utilities, and this is accepted, so long as they do not remove more material than what is required by codes. This type of floor system is usually the cheapest to install.
Of all, the most commonly installed flooring system are framed floors. They consist of dimensioned lumber, bearing on exterior and interior load bearing walls or beams called "floor joists". Generally the floor joists are installed, spaced 16" apart. Installing rim and trimmer joists, to which the floor joists are nailed, finishes the perimeter. Bracing, usually in the form of bridging, but often installed as strapping, prevents the joists from turning in place. One other method used to prevent this type of turning is to glue the sub-flooring to the joists, as the sub-floor is placed.
Raw sheathing comes in 4`x8` sheets, most often installed as 3/4" thick plywood panels. This type of sheathing is adequate for spanning joist work spaced up to 24" apart. The sheathing is lain with the joints staggered in such a matter, that no two edge joints line up with adjoining sheets. It is very easy to install, requiring the least amount of labour. The sheets are fastened with either 1-1/2" flooring screws, or 2-1/2" nails, spaced about 8" apart. Although not required, it is a good idea to provide backers or supports under the joints, between sheets which run perpendicular to the framed floor assembly.
Hardwood flooring is often a generic term that could apply to any type of wood flooring. Hardwood trees (oak, maple, cherry, walnut, elm, chestnut) are generally trees that had leaves which fall off in the winter. Softwood trees (pine, fir) have needles that may stay on all year and usually they produce cones. Hardwoods are usually more dense and more durable than softwoods. Of course, there are exceptions to these generalities. In our product line the hardwoods cost more than the softwoods.