Belda Flooring July 13th, 2017 - 19:23:53
Strip floors, were once the most popular type of sub-floor installed. But with the introduction of manufactured sheathing products, it has become less utilized. Strip floors consist of 1" by 6" or 8" boards, placed diagonally over the floor joist framing system. It is slightly more expensive to install, and requires experienced tradesmen. To install such floors properly, the lumber should be non-kiln dried, with a relatively high moisture content. This may seem odd, but in reality, as the wood dries out, it will shrink.
Dust, grit and moisture are gifts of nature and we all have to deal with them. Grit which stems from sand or dirt being tracked from the outdoors on the surface works like sandpaper on the floor finish. Dust mites, balls and the like are merely pulverized bits of dirt which in essence acts in the same way as grit over the long haul on your floors. Once your floor finish gets damaged grit and dust left on the surface tend to discolor the hardwood while being ground into the surface pores with each step made on top of it like a hammer pounding stroke after stroke.
The third variable is installation costs. Our engineered product has labor savings over our solid wood product because it is pre-sanded and milled to tighter tolerances. It is also prefilled in the holes and has next to zero waste. On the other hand you may have a little more in cost of gluing it down in addition to nails, but this is just a step in direction of better quality and peace of mind during the install.
Another good flooring for wet areas is the vinyl tile. Typically it is manufactured in much the same way as sheet vinyl, but is much more rigid and comes as 12"x12" square units. They are installed in the much the same way, but require skilled tradesmen, familiar with proper installation. A good installer will start from the middle of the room to ensure that all cut tiles are equal in width at opposing walls. One advantage to this type of flooring, over sheet vinyl, is that it is can be installed, without danger of joint separation, over large areas. For this reason, it is often used in commercial buildings where large rooms are the norm. Vinyl tile can also be easily installed directly to concrete floors. Like vinyl sheets, it too is resistant to water, and tends to be installed in the areas of a building, prone to water accumulations. Tile, can be easily cleaned, is relatively maintenance free, and one of the cheaper finished floors to install.