Orlene Flooring July 19th, 2017 - 19:33:41
I encourage you being cautious about potential discoloring of the wood floor in direct proportion to the shape of the center rug piece over time. Discoloration will occur not as a result of the throw rug or center rug piece but as a result of sunlight beaming on the wooden floor in areas around the center rug piece. You see, underneath the center rug piece sunlight cannot get to the wood. So, the color of your wooden floor beneath the center rug piece would be lighter in color over time than the exposed areas. I recommend you use throw/scatter rugs instead of center piece or area rugs as these would be more readily removed, freshened or relocated to minimize a lengthy tenure in one location.
However if you go for a quality engineered wood flooring you can even gone as far as to boil a piece of our floor for 30 minutes and the board still will not de-laminate. The 15mm ply wood under core is what gives the flooring the strength and stability is has. Oak is a natural product and when used for flooring the board widths can change in size. This can cause gaps between boards or the floor to buckle and this movement is most commonly caused by the changing of humidity in the environment. Because of the stability of a quality engineered oak floor it is far less prone to this movement. This stability is also becoming of greater importance today due to the fact that an increasing number of properties are having under floor heating systems installed, which of course causes a frequent change in humidity. Having said this I would again like to reiterate that I am writing in regards to a quality, higher spec engineered oak flooring, and I can not talk for all engineered wood floors.
Here is a word on prefinished product if they factor into your decision. If you come up short on your order, the next lot that you buy may not match your previous batch. This is especially a problem on the lower end price floors and import floors. Good luck trying to blend it in with your previous floor. So if you go this route, be extra accurate on your measurements. Right now the rage is lifetime warranties on flooring. We stop to think is that really even possible? First will that importer or manufacturer really be around a lifetime? A lot of products are made oversees; the warranty is only good if there is somebody still around for the life of the warranty.
If your price-point is not even in the same zip code, maybe it is in a different state, start shopping other options. For example if you are in the $1-2/sf range look at the deep discounters or laminate options. The FSC certified 12mm exterior birch plywood that we use to manufacturer the engineered flooring costs us that much alone, not counting all the other labor and materials.