Lundy Flooring July 15th, 2017 - 19:10:54
Seventh, are you a do-it-yourselfer? Think through every step of the process to be sure that you can do it yourself. Usually the install can be done with relatively moderate skills and simple tools like a chop saw and rented flooring nailer. The finishing process is a whole different matter. The sanders and buffers take some special skills to operate. A normal price range for labor and materials to install a wood floor is $4-5 per square foot. It is possible to build your own sweat equity into a floor install. Maybe this is where you choose to use our engineered product for example because it is presanded to more accurate tolerances than a solid wood product. It can be touched up with a hand held orbital sander rather than industrial floor sanders. Then if you are doing the finish yourself, you will want to consider using a finish that may not require as much buffing between coats.
Raw sheathing comes in 4`x8` sheets, most often installed as 3/4" thick plywood panels. This type of sheathing is adequate for spanning joist work spaced up to 24" apart. The sheathing is lain with the joints staggered in such a matter, that no two edge joints line up with adjoining sheets. It is very easy to install, requiring the least amount of labour. The sheets are fastened with either 1-1/2" flooring screws, or 2-1/2" nails, spaced about 8" apart. Although not required, it is a good idea to provide backers or supports under the joints, between sheets which run perpendicular to the framed floor assembly.
Ceramic tile is probably the most durable types of flooring and is typically installed in entry areas, where sand scuffing and water accumulations are the norm. Bathrooms and kitchens often get this type of floor treatment as well, but due to the high cost of installation, homeowners tend to not include these areas. Ceramic tile are typically a square tile, although interlocking units are on the market, in standard square measurements of 4", 6",8" or 12". They are installed by one of two primary methods, either set into a thin mortar bed (called "thinset adhesive"), which also acts like glue, or a heavyset bed of 1-1/2" normal mortar base. For all ceramic tile installations, the floor must be built up to ensure the strength required to prevent tile or joint cracking. Often, installers put down a material called "cement board", which is much like drywall, but is made of glass fibers and cement. In any case, ensure that your installer will offer you a guarantee against future cracking or uplift of tiles. Ceramic tiles require little maintenance, but beware, water on glossy floor tiles can be very slippery, and many a time, a homeowner has resented the installation of a high gloss tile, over a bathroom floor area.
Most commonly installed are interlocking sheathing panels. This type of sheathing is generally 5/8" thick, and manufactured as either plywood or aspenite (commonly referred to as "chipboard") in 4` x 8` sheets. The sheets come with the long edges designed to interlock with a tongue on one edge, and a grove on the opposing edge. They are installed by simply pushing or pounding the sheets together, and nailing or screwing them to the joist work, in the same manner as raw sheathing. It is often the cheapest to install.