Lundy Flooring July 15th, 2017 - 19:14:48
With reclaimed material waste factor is a huge variable. How much effort does the manufacturer take to give you a 100% usable product? Poorly milled with very little defecting and culling done on a solid wood floor that costs $6/sf and has a 15% waste factor actually costs more than a similar product that is milled better costing $7/sf with a 2% waste factor. That extra wastes costs more in shipping and labor to defect. This is one of the hardest things to demonstrate to a customer that the face value costs doesn`t necessarily represent the actual raw material cost unless one is truly comparing identical quality and specified products.
Carpet is probably the most common floor covering that is used in residential homes. It comes in a wide variety of colors and textures. Carpet consists of woven fibers, which protrude upwards, glued or woven into a foam or jute backing. Often an underpad of pressed foam is installed below it or the backing can be integral with the carpet, adding to the softness and providing a much more comfortable surface for walking on. Carpet is installed by either gluing the carpet to the sub-floor, or the use of carpet tack around the perimeter. A good carpet will has a close weave, which will not show the backing material when separated. To reduce project costs, some contractors will opt to install a high quality underlay, with a low or medium quality carpet. This provides the soft surface, with equal durability, giving the homeowner the benefits of high quality carpet, at a reduced cost.
Some think of interlocking tiles and immediately think of ugly, heavy, rubber flooring used in the industrial sector. This could not be further from the truth. While interlocking tiles were initially created to serve the industrial sector, they have come a long way since that time. Interlocking floor tiles are now available in an array of finishes and material types. They can be purchased in rubber, plastic, vinyl and porcelain, among many other high quality materials. Virtually any tile material that can be used in a traditional installation can also be used in interlocking floor tiles.
Raw sheathing comes in 4`x8` sheets, most often installed as 3/4" thick plywood panels. This type of sheathing is adequate for spanning joist work spaced up to 24" apart. The sheathing is lain with the joints staggered in such a matter, that no two edge joints line up with adjoining sheets. It is very easy to install, requiring the least amount of labour. The sheets are fastened with either 1-1/2" flooring screws, or 2-1/2" nails, spaced about 8" apart. Although not required, it is a good idea to provide backers or supports under the joints, between sheets which run perpendicular to the framed floor assembly.