Nynette Flooring July 20th, 2017 - 21:12:48
Seventh, are you a do-it-yourselfer? Think through every step of the process to be sure that you can do it yourself. Usually the install can be done with relatively moderate skills and simple tools like a chop saw and rented flooring nailer. The finishing process is a whole different matter. The sanders and buffers take some special skills to operate. A normal price range for labor and materials to install a wood floor is $4-5 per square foot. It is possible to build your own sweat equity into a floor install. Maybe this is where you choose to use our engineered product for example because it is presanded to more accurate tolerances than a solid wood product. It can be touched up with a hand held orbital sander rather than industrial floor sanders. Then if you are doing the finish yourself, you will want to consider using a finish that may not require as much buffing between coats.
Ceramic tile is probably the most durable types of flooring and is typically installed in entry areas, where sand scuffing and water accumulations are the norm. Bathrooms and kitchens often get this type of floor treatment as well, but due to the high cost of installation, homeowners tend to not include these areas. Ceramic tile are typically a square tile, although interlocking units are on the market, in standard square measurements of 4", 6",8" or 12". They are installed by one of two primary methods, either set into a thin mortar bed (called "thinset adhesive"), which also acts like glue, or a heavyset bed of 1-1/2" normal mortar base. For all ceramic tile installations, the floor must be built up to ensure the strength required to prevent tile or joint cracking. Often, installers put down a material called "cement board", which is much like drywall, but is made of glass fibers and cement. In any case, ensure that your installer will offer you a guarantee against future cracking or uplift of tiles. Ceramic tiles require little maintenance, but beware, water on glossy floor tiles can be very slippery, and many a time, a homeowner has resented the installation of a high gloss tile, over a bathroom floor area.
Did you see a picture that you like and now you have the bug that you want that special floor? The good news is that it could probably be made for you, but before you go a long ways down the path of choosing which floor you want and requesting a display room full of samples, ask about some price ranges. There is a common misconception that since reclaimed wood is supposedly salvaged it should be cheaper than virgin wood floors. If you are buying a quality kiln dried and precision milled product, generally that is not the case. The only cost savings would be if you found some scraps or did some salvage work yourself, you might save some costs. For example you might find a gym floor or planks out of a barn hay loft that you want to nail down on your floor. The material might have been next to free, but how much time are you going to have in making it usable and pulling nails? Are the results what you want?
There are three main types of sub-flooring installed to cover and span the floor structure. It is over this that the finished floor will be placed. The sub-flooring types include raw sheathing, interlocking and strip. It is utilized not only to provide a surface for the interior finishes to be placed on, but also to prevent twisting or torque forces placed on the building. The sub-floor also allows load sharing within the joist framing system. Often the sub-flooring is glued to the joist work to eliminate creaking floors and to prevent the floor joists from turning.