Nynette Flooring July 20th, 2017 - 20:42:30
Of all, the most commonly installed flooring system are framed floors. They consist of dimensioned lumber, bearing on exterior and interior load bearing walls or beams called "floor joists". Generally the floor joists are installed, spaced 16" apart. Installing rim and trimmer joists, to which the floor joists are nailed, finishes the perimeter. Bracing, usually in the form of bridging, but often installed as strapping, prevents the joists from turning in place. One other method used to prevent this type of turning is to glue the sub-flooring to the joists, as the sub-floor is placed.
So, a top quality oak engineered flooring will look the same but will it actually last as long?. How long a floor will last is mostly down to something called its `wear layer`. The part of the floor that is classed as the wear layer is from the surface of the board down to the tongue and on a solid oak board this would be around 5-6mm. Now, the wear layer on engineered wood flooring is the top layer of oak. So if you purchase an engineered oak flooring which has a 5-6mm solid oak top layer it will result in the flooring lasting just as long. In conclusion if you want an engineered flooring that is going to last as long as a traditional solid oak floor then make sure it has a nice thick top layer of wood, ideally 5mm+.
Installing interlocking floor tiles is a much easier and user friendly process. They are designed to clip together, eliminating the need for measuring spaces and also leaving room for the tiles to settle. Each tile is surrounded with divots that lock to the other interlocking floor tiles. They clip together easily, much like a jigsaw puzzle, and allow a perfect seamless finish. If a mistake is made while installing the interlocking tiles, it is easy to fix. Simply pull them apart and start over. As no adhesive is generally used, they do not need to be pried up, risking damage to the floor.
Truss floors are simply that. They are constructed from small dimensioned lumber, interconnected in a webwork pattern by the use of metal or wood plates. Occasionally, the trusses will be built on site, utilizing plywood plates to connect the webwork together. Generally they are installed 24" apart, either suspended on bearing walls or beams, or installed with plywood trim or rim joists around the perimeter. Strapping is installed on the bottom side, to prevent turning in place, which is a common ailment for deep truss components.