Calantha Flooring July 29th, 2017 - 19:15:17
For the second variable here is a controversial opinion: we do not end match our flooring which means there is no tongue and groove on the ends of the planks. Since we recommend our floor be glued down we say this is an unnecessary expense for the customer. End matching reduces the yield in production and raises labor costs. Most end match profiles are milled so loosely that they really don`t hold the floor in place anyway. The biggest benefit to the installer is that the plank can be cut in half in any place and reused anywhere without have to mate up to a complementary tongue or groove since the end is just square cut. This means all end trim pieces or any waste can be reused. Therefore on our engineered flooring product the waste factor is virtually nothing unless there are angles or radiuses to work around. We also help with waste factor by usually supplying a random width product so when one gets close to the end of a room they can plan the width combination patterns out to not have to rip much off the last row.
Most popularly used in bathrooms, kitchens, laundry areas and entryways are vinyl sheet, or linoleum floorings. This type of flooring cones in a vast array of colors, textures and patterns, in sheet sizes of 12 foot widths with varying lengths, and made from a vinyl composite, covered with a surface coating. It is installed by applying covering over the sub-floor, usually mahogany or particle core sheets 4`x4` in size, to which the vinyl is glued to. It can also be installed directly onto concrete floors, in areas such as basements. Joining two sheets together is a standard practice when the room width exceeds 12`, or under doorways. Sheet vinyl is a good flooring in areas where water tends to accumulate, like around bathroom fixtures or at entry ways. It is fairly durable, and often maintenance free. Linoleum is one of the cheapest types of flooring to install.
Some think of interlocking tiles and immediately think of ugly, heavy, rubber flooring used in the industrial sector. This could not be further from the truth. While interlocking tiles were initially created to serve the industrial sector, they have come a long way since that time. Interlocking floor tiles are now available in an array of finishes and material types. They can be purchased in rubber, plastic, vinyl and porcelain, among many other high quality materials. Virtually any tile material that can be used in a traditional installation can also be used in interlocking floor tiles.
Are you going to be able to enforce the warranty? Also, do you really think that a finish can last a lifetime? For example take a nail and try scraping it across the surface. Sure it is a durable, well applied finish, but it is impossible to make a product that won`t get abused at some point in its lifetime. Do you think that the only serious trial your floor will ever see is a stinky sock? Read the fine print on the warranty and regardless of what it says consider the true replacement cost on the floor. It probably only covers the cost of material of the specific damaged product under normal wear and tear. Your product may not be made exactly the same later (trends and product lines change) to replace the section that is warrantied, so you may have to replace the whole floor years later. You will have labor cost along with displacement of trim, cabinets, and appliances. Also most of these lifetime finishes cannot be repaired or sanded because of a micro bevel put on the edge of prefinished floor. Our advice is instead to buy a quality product that can be refinished and repaired because something will go wrong in the lifetime of the floor; don`t get a false sense of security.