Nanine Flooring July 15th, 2017 - 18:24:07
We personally do not care for prefinished flooring due to installation problems associated with it, so our product requires site applied finish. This means that your floor finish if site applied will be easier to sand and refinish than a prefinished floor. Also you do not have to deal with that micro bevel groove between each board that tends to fill up with dust and crumbs. Most prefinished hardwood floors really can`t be refinished easily. To sand it off means that the wear layer has to be thicker than the height of the nails and have room to sand off the micro bevel between boards; that amounts to a lot of sanding. You also will not be able to spot sand or touch up parts of the floor.
Raw sheathing comes in 4`x8` sheets, most often installed as 3/4" thick plywood panels. This type of sheathing is adequate for spanning joist work spaced up to 24" apart. The sheathing is lain with the joints staggered in such a matter, that no two edge joints line up with adjoining sheets. It is very easy to install, requiring the least amount of labour. The sheets are fastened with either 1-1/2" flooring screws, or 2-1/2" nails, spaced about 8" apart. Although not required, it is a good idea to provide backers or supports under the joints, between sheets which run perpendicular to the framed floor assembly.
Most commonly installed are interlocking sheathing panels. This type of sheathing is generally 5/8" thick, and manufactured as either plywood or aspenite (commonly referred to as "chipboard") in 4` x 8` sheets. The sheets come with the long edges designed to interlock with a tongue on one edge, and a grove on the opposing edge. They are installed by simply pushing or pounding the sheets together, and nailing or screwing them to the joist work, in the same manner as raw sheathing. It is often the cheapest to install.
Fifth, compare overall thickness and the height from the top of the tongue or nail groove to the top of the face on the floor. On an engineered floor this is generally the thickness of a wear layer. Most solid wood floors are 3/4" overall before sanding (but some are less) with 1/4" above the nail groove. Our engineered floor is manufactured to equivalent measurements but most engineered floors have a thinner wear layer. This comes down to how many times the floor can be sanded. What kind of finish and texture you want on the floor factors into how deep you will re-sand the floor during refinishing. A number of our reclaimed wood floors are sold with an original texture that shows the old saw marks and character in the floor, so most likely you won`t want to sand this out. As a rule of thumb, the thicker the wear layer then the longer the floor will last.