Calantha Flooring July 30th, 2017 - 19:30:43
We personally do not care for prefinished flooring due to installation problems associated with it, so our product requires site applied finish. This means that your floor finish if site applied will be easier to sand and refinish than a prefinished floor. Also you do not have to deal with that micro bevel groove between each board that tends to fill up with dust and crumbs. Most prefinished hardwood floors really can`t be refinished easily. To sand it off means that the wear layer has to be thicker than the height of the nails and have room to sand off the micro bevel between boards; that amounts to a lot of sanding. You also will not be able to spot sand or touch up parts of the floor.
Traditional tile installation requires many tools and lots of patience which have to be pre-set on the floor, cut down to size, then adhered to the floor using a strong industrial glue. They will not stick to every surface and frequently, a layer of floor base must be installed before the tiling work can begin. If the tiles are placed too close together, they can buckle, leaving unsightly bumps and lumps on the floor. If they are placed too far apart, there will be obvious gaps. If a mistake is made when laying down the tile, it is very difficult to fix as the tile is glued to the floor. The tile will have to be pried up, excess adhesive scraped, and the process started over. Laying traditional tile floors is a project that can take several days, to several weeks, to finish.
Strip floors, were once the most popular type of sub-floor installed. But with the introduction of manufactured sheathing products, it has become less utilized. Strip floors consist of 1" by 6" or 8" boards, placed diagonally over the floor joist framing system. It is slightly more expensive to install, and requires experienced tradesmen. To install such floors properly, the lumber should be non-kiln dried, with a relatively high moisture content. This may seem odd, but in reality, as the wood dries out, it will shrink.
Raw sheathing comes in 4`x8` sheets, most often installed as 3/4" thick plywood panels. This type of sheathing is adequate for spanning joist work spaced up to 24" apart. The sheathing is lain with the joints staggered in such a matter, that no two edge joints line up with adjoining sheets. It is very easy to install, requiring the least amount of labour. The sheets are fastened with either 1-1/2" flooring screws, or 2-1/2" nails, spaced about 8" apart. Although not required, it is a good idea to provide backers or supports under the joints, between sheets which run perpendicular to the framed floor assembly.