Calantha Flooring August 09th, 2017 - 18:47:36
Carpet is probably the most common floor covering that is used in residential homes. It comes in a wide variety of colors and textures. Carpet consists of woven fibers, which protrude upwards, glued or woven into a foam or jute backing. Often an underpad of pressed foam is installed below it or the backing can be integral with the carpet, adding to the softness and providing a much more comfortable surface for walking on. Carpet is installed by either gluing the carpet to the sub-floor, or the use of carpet tack around the perimeter. A good carpet will has a close weave, which will not show the backing material when separated. To reduce project costs, some contractors will opt to install a high quality underlay, with a low or medium quality carpet. This provides the soft surface, with equal durability, giving the homeowner the benefits of high quality carpet, at a reduced cost.
Hardwood flooring is often a generic term that could apply to any type of wood flooring. Hardwood trees (oak, maple, cherry, walnut, elm, chestnut) are generally trees that had leaves which fall off in the winter. Softwood trees (pine, fir) have needles that may stay on all year and usually they produce cones. Hardwoods are usually more dense and more durable than softwoods. Of course, there are exceptions to these generalities. In our product line the hardwoods cost more than the softwoods.
In the case of long span truss work, bearing lengths of at least 3" are quite common. Trusses span greater distances than framed floor assemblies and can be designed to span the entire building, eliminating center load bearing supports. They are moderately more expensive than framed floor assemblies, but provide a remarkably strong floor with little deflection or "bounce" to it. Another advantage to this type of structural system, is that utility installations can be run between the webwork components. Never allow trades to cut or drill into the members of a truss, for they are manufactured precisely for the loading conditions they will undergo during the life of the building.
The manufactured joist, which is a relatively new product, is often manufactured from low cost materials in the shape of an I beam, similar to steel beams in larger buildings. What this means is that the joist is constructed with a thicker top and bottom edge, and generally interlocking aspenite vertically spanning between the two. These systems are very strong, often capable of spanning the entire width of the building.