Orlene Flooring July 31st, 2017 - 20:17:05
Some think of interlocking tiles and immediately think of ugly, heavy, rubber flooring used in the industrial sector. This could not be further from the truth. While interlocking tiles were initially created to serve the industrial sector, they have come a long way since that time. Interlocking floor tiles are now available in an array of finishes and material types. They can be purchased in rubber, plastic, vinyl and porcelain, among many other high quality materials. Virtually any tile material that can be used in a traditional installation can also be used in interlocking floor tiles.
Ceramic tile is probably the most durable types of flooring and is typically installed in entry areas, where sand scuffing and water accumulations are the norm. Bathrooms and kitchens often get this type of floor treatment as well, but due to the high cost of installation, homeowners tend to not include these areas. Ceramic tile are typically a square tile, although interlocking units are on the market, in standard square measurements of 4", 6",8" or 12". They are installed by one of two primary methods, either set into a thin mortar bed (called "thinset adhesive"), which also acts like glue, or a heavyset bed of 1-1/2" normal mortar base. For all ceramic tile installations, the floor must be built up to ensure the strength required to prevent tile or joint cracking. Often, installers put down a material called "cement board", which is much like drywall, but is made of glass fibers and cement. In any case, ensure that your installer will offer you a guarantee against future cracking or uplift of tiles. Ceramic tiles require little maintenance, but beware, water on glossy floor tiles can be very slippery, and many a time, a homeowner has resented the installation of a high gloss tile, over a bathroom floor area.
We personally do not care for prefinished flooring due to installation problems associated with it, so our product requires site applied finish. This means that your floor finish if site applied will be easier to sand and refinish than a prefinished floor. Also you do not have to deal with that micro bevel groove between each board that tends to fill up with dust and crumbs. Most prefinished hardwood floors really can`t be refinished easily. To sand it off means that the wear layer has to be thicker than the height of the nails and have room to sand off the micro bevel between boards; that amounts to a lot of sanding. You also will not be able to spot sand or touch up parts of the floor.
The final advantage of engineered wood flooring over solid oak flooring that I am gong to mention is how an engineered oak floor is more environmentally friendly. The plywood that is used is made up of fast growing softwoods which are plentiful and this is what the under side of our engineered wood flooring is constructed of. This means that far less of our valued oak, which has taken hundreds of years to grow, is used resulting in a much more environmentally friendly flooring.