Nynette Flooring July 28th, 2017 - 19:40:31
Most commonly installed are interlocking sheathing panels. This type of sheathing is generally 5/8" thick, and manufactured as either plywood or aspenite (commonly referred to as "chipboard") in 4` x 8` sheets. The sheets come with the long edges designed to interlock with a tongue on one edge, and a grove on the opposing edge. They are installed by simply pushing or pounding the sheets together, and nailing or screwing them to the joist work, in the same manner as raw sheathing. It is often the cheapest to install.
However if you go for a quality engineered wood flooring you can even gone as far as to boil a piece of our floor for 30 minutes and the board still will not de-laminate. The 15mm ply wood under core is what gives the flooring the strength and stability is has. Oak is a natural product and when used for flooring the board widths can change in size. This can cause gaps between boards or the floor to buckle and this movement is most commonly caused by the changing of humidity in the environment. Because of the stability of a quality engineered oak floor it is far less prone to this movement. This stability is also becoming of greater importance today due to the fact that an increasing number of properties are having under floor heating systems installed, which of course causes a frequent change in humidity. Having said this I would again like to reiterate that I am writing in regards to a quality, higher spec engineered oak flooring, and I can not talk for all engineered wood floors.
Laying the floor is also another area that is worth thinking about when comparing the two types of oak flooring. The majority of engineered wood floors are longer and wider than most solid oak boards because this is the look that most people are wanting nowadays. The flooring being longer and wider means the flooring is quicker to fit. Another aspect that makes this floor easier and quicker to fit is how well machined the boards are. From our experience in the flooring industry we have had nothing but good feedback regarding how easy our engineered flooring was to lay, and this is down to how well machined the boards are. Given that engineered flooring is quicker and easier to fit, any extra money that is spent on purchasing an engineered oak floor is often compensated in the time that is saved fitting it! This is something to keep in mind when comparing prices.
Strip floors, were once the most popular type of sub-floor installed. But with the introduction of manufactured sheathing products, it has become less utilized. Strip floors consist of 1" by 6" or 8" boards, placed diagonally over the floor joist framing system. It is slightly more expensive to install, and requires experienced tradesmen. To install such floors properly, the lumber should be non-kiln dried, with a relatively high moisture content. This may seem odd, but in reality, as the wood dries out, it will shrink.