Aveline Flooring July 27th, 2017 - 18:17:06
Another good flooring for wet areas is the vinyl tile. Typically it is manufactured in much the same way as sheet vinyl, but is much more rigid and comes as 12"x12" square units. They are installed in the much the same way, but require skilled tradesmen, familiar with proper installation. A good installer will start from the middle of the room to ensure that all cut tiles are equal in width at opposing walls. One advantage to this type of flooring, over sheet vinyl, is that it is can be installed, without danger of joint separation, over large areas. For this reason, it is often used in commercial buildings where large rooms are the norm. Vinyl tile can also be easily installed directly to concrete floors. Like vinyl sheets, it too is resistant to water, and tends to be installed in the areas of a building, prone to water accumulations. Tile, can be easily cleaned, is relatively maintenance free, and one of the cheaper finished floors to install.
Strip floors, were once the most popular type of sub-floor installed. But with the introduction of manufactured sheathing products, it has become less utilized. Strip floors consist of 1" by 6" or 8" boards, placed diagonally over the floor joist framing system. It is slightly more expensive to install, and requires experienced tradesmen. To install such floors properly, the lumber should be non-kiln dried, with a relatively high moisture content. This may seem odd, but in reality, as the wood dries out, it will shrink.
There are three main types of sub-flooring installed to cover and span the floor structure. It is over this that the finished floor will be placed. The sub-flooring types include raw sheathing, interlocking and strip. It is utilized not only to provide a surface for the interior finishes to be placed on, but also to prevent twisting or torque forces placed on the building. The sub-floor also allows load sharing within the joist framing system. Often the sub-flooring is glued to the joist work to eliminate creaking floors and to prevent the floor joists from turning.
Working in the flooring industry we often have customers calling us because they are interested in a solid oak floor. More often than not we end up suggesting they go down the engineered route and then being asked the same thing, `why choose an engineered wood floor over a solid oak floor and does it really feel and look as beautiful?` We are writing this article to briefly outline the main advantages of our engineered wood flooring and why now so many people are choosing the engineered over the traditional solid oak flooring. Throughout this article I will write in reference to a top quality engineered oak flooring with multiple layers of ply wood under core and a thick, long lasting wear layer. I can not speak on behalf of all engineered wood floors as they differ massively in quality and price. In all cases you need to check thoroughly the specifications of the product on offer.