Aveline Flooring August 03rd, 2017 - 19:55:42
Dust, grit and moisture are gifts of nature and we all have to deal with them. Grit which stems from sand or dirt being tracked from the outdoors on the surface works like sandpaper on the floor finish. Dust mites, balls and the like are merely pulverized bits of dirt which in essence acts in the same way as grit over the long haul on your floors. Once your floor finish gets damaged grit and dust left on the surface tend to discolor the hardwood while being ground into the surface pores with each step made on top of it like a hammer pounding stroke after stroke.
In a reclaimed product the engineered flooring really shines. Since the nature of reclaimed material is rustic with splits, various height, warps and so forth by doing an engineered product we can eliminate those issues. We match the texture and color that you want in the floor but you don`t have to put up with the inherent problems that come with installing and living with a reclaimed wood floor. A number of solid wood reclaimed floors have warped and twisted boards, gaps between rows, height difference between rows, holes, and other "nostalgia and romance" that may become unwelcome after living with the floor for a while. Due to our precise sanding during the lamination process for the engineered product and after, pieces are more consistent in height, more uniform in texture, fit together tighter, no waste, holes and cracks already filled, and no sanding necessary after install unless you want to do a light screen or buff.
In this article we will be discussing several different categories of wood flooring. Solid wood flooring is one board with no glued up laminations; it is basically wood board that has been sized and profiled to a certain dimension. Engineered flooring has a on the top whatever species and texture you want, and this is glued to a plywood backer on the bottom. Engineered is still all wood but is made with multiple layers that are laminated for better stability and dimensional accuracy. Floors that we will not cover here are laminates or any composite products which are often not wood entirely through the plank or may be made with a photo printed surface. We also will not cover vinyl, carpet, stone, or tile.
However if you go for a quality engineered wood flooring you can even gone as far as to boil a piece of our floor for 30 minutes and the board still will not de-laminate. The 15mm ply wood under core is what gives the flooring the strength and stability is has. Oak is a natural product and when used for flooring the board widths can change in size. This can cause gaps between boards or the floor to buckle and this movement is most commonly caused by the changing of humidity in the environment. Because of the stability of a quality engineered oak floor it is far less prone to this movement. This stability is also becoming of greater importance today due to the fact that an increasing number of properties are having under floor heating systems installed, which of course causes a frequent change in humidity. Having said this I would again like to reiterate that I am writing in regards to a quality, higher spec engineered oak flooring, and I can not talk for all engineered wood floors.