Nynette Flooring July 20th, 2017 - 19:59:18
Carpet is probably the most common floor covering that is used in residential homes. It comes in a wide variety of colors and textures. Carpet consists of woven fibers, which protrude upwards, glued or woven into a foam or jute backing. Often an underpad of pressed foam is installed below it or the backing can be integral with the carpet, adding to the softness and providing a much more comfortable surface for walking on. Carpet is installed by either gluing the carpet to the sub-floor, or the use of carpet tack around the perimeter. A good carpet will has a close weave, which will not show the backing material when separated. To reduce project costs, some contractors will opt to install a high quality underlay, with a low or medium quality carpet. This provides the soft surface, with equal durability, giving the homeowner the benefits of high quality carpet, at a reduced cost.
So, a top quality oak engineered flooring will look the same but will it actually last as long?. How long a floor will last is mostly down to something called its `wear layer`. The part of the floor that is classed as the wear layer is from the surface of the board down to the tongue and on a solid oak board this would be around 5-6mm. Now, the wear layer on engineered wood flooring is the top layer of oak. So if you purchase an engineered oak flooring which has a 5-6mm solid oak top layer it will result in the flooring lasting just as long. In conclusion if you want an engineered flooring that is going to last as long as a traditional solid oak floor then make sure it has a nice thick top layer of wood, ideally 5mm+.
We personally do not care for prefinished flooring due to installation problems associated with it, so our product requires site applied finish. This means that your floor finish if site applied will be easier to sand and refinish than a prefinished floor. Also you do not have to deal with that micro bevel groove between each board that tends to fill up with dust and crumbs. Most prefinished hardwood floors really can`t be refinished easily. To sand it off means that the wear layer has to be thicker than the height of the nails and have room to sand off the micro bevel between boards; that amounts to a lot of sanding. You also will not be able to spot sand or touch up parts of the floor.
Traditional tile installation requires many tools and lots of patience which have to be pre-set on the floor, cut down to size, then adhered to the floor using a strong industrial glue. They will not stick to every surface and frequently, a layer of floor base must be installed before the tiling work can begin. If the tiles are placed too close together, they can buckle, leaving unsightly bumps and lumps on the floor. If they are placed too far apart, there will be obvious gaps. If a mistake is made when laying down the tile, it is very difficult to fix as the tile is glued to the floor. The tile will have to be pried up, excess adhesive scraped, and the process started over. Laying traditional tile floors is a project that can take several days, to several weeks, to finish.