Lundy Flooring July 15th, 2017 - 18:23:49
Installing interlocking floor tiles is a much easier and user friendly process. They are designed to clip together, eliminating the need for measuring spaces and also leaving room for the tiles to settle. Each tile is surrounded with divots that lock to the other interlocking floor tiles. They clip together easily, much like a jigsaw puzzle, and allow a perfect seamless finish. If a mistake is made while installing the interlocking tiles, it is easy to fix. Simply pull them apart and start over. As no adhesive is generally used, they do not need to be pried up, risking damage to the floor.
Another way to prevent undue and excessive wear on your hardwood floors or wooden floors is to use scatter or throw rugs in high traffic areas. You may even be tempted to use a center rug piece for decor. Now that you and I have gotten past the fun stair rail slide and onto the floor, it is utterly important that we stay clear of injury -- Ensure that your throw, scatter or centerpiece rug either has sufficient non-skid backing or that you lay a non-slip material between it and your wood floor.
Undoubtedly you`ve seen wood floors where it seems that the edges or seams of boards joined together curl up or the width of a board creates a bow like upward arc in the middle. These are indications of moisture damage to a wooden floor. For example, there have even been instances where moisture damage caused floor boards to arc together to raise a full length sofa about three feet into the air. That was merely from the curl effect and strength of water on wooden floor boards. So, by all means do dry any spills to keep moisture and liquids away from your wooden floors.
Fifth, compare overall thickness and the height from the top of the tongue or nail groove to the top of the face on the floor. On an engineered floor this is generally the thickness of a wear layer. Most solid wood floors are 3/4" overall before sanding (but some are less) with 1/4" above the nail groove. Our engineered floor is manufactured to equivalent measurements but most engineered floors have a thinner wear layer. This comes down to how many times the floor can be sanded. What kind of finish and texture you want on the floor factors into how deep you will re-sand the floor during refinishing. A number of our reclaimed wood floors are sold with an original texture that shows the old saw marks and character in the floor, so most likely you won`t want to sand this out. As a rule of thumb, the thicker the wear layer then the longer the floor will last.