Calantha Flooring August 01st, 2017 - 18:49:34
I encourage you being cautious about potential discoloring of the wood floor in direct proportion to the shape of the center rug piece over time. Discoloration will occur not as a result of the throw rug or center rug piece but as a result of sunlight beaming on the wooden floor in areas around the center rug piece. You see, underneath the center rug piece sunlight cannot get to the wood. So, the color of your wooden floor beneath the center rug piece would be lighter in color over time than the exposed areas. I recommend you use throw/scatter rugs instead of center piece or area rugs as these would be more readily removed, freshened or relocated to minimize a lengthy tenure in one location.
Are you going to be able to enforce the warranty? Also, do you really think that a finish can last a lifetime? For example take a nail and try scraping it across the surface. Sure it is a durable, well applied finish, but it is impossible to make a product that won`t get abused at some point in its lifetime. Do you think that the only serious trial your floor will ever see is a stinky sock? Read the fine print on the warranty and regardless of what it says consider the true replacement cost on the floor. It probably only covers the cost of material of the specific damaged product under normal wear and tear. Your product may not be made exactly the same later (trends and product lines change) to replace the section that is warrantied, so you may have to replace the whole floor years later. You will have labor cost along with displacement of trim, cabinets, and appliances. Also most of these lifetime finishes cannot be repaired or sanded because of a micro bevel put on the edge of prefinished floor. Our advice is instead to buy a quality product that can be refinished and repaired because something will go wrong in the lifetime of the floor; don`t get a false sense of security.
We personally do not care for prefinished flooring due to installation problems associated with it, so our product requires site applied finish. This means that your floor finish if site applied will be easier to sand and refinish than a prefinished floor. Also you do not have to deal with that micro bevel groove between each board that tends to fill up with dust and crumbs. Most prefinished hardwood floors really can`t be refinished easily. To sand it off means that the wear layer has to be thicker than the height of the nails and have room to sand off the micro bevel between boards; that amounts to a lot of sanding. You also will not be able to spot sand or touch up parts of the floor.
Many people also have questions about the tiles durability and use. Interlocking floor tiles are usually placed on the floor underneath it, meaning there is no adhesive or floor base. Some may become concerned that the interlocking tiles will become loose easily due to the lack of adhesive. This is not the case. Tile floor systems are designed to lock together permanently. When appropriately installed, the interlocking floor tile should remain exactly as it was placed until the user decides to move it. Interlocking tile floors are appropriate for any use, from industrial to residential. This interlocking flooring system does not have as much risks compared to traditional tile flooring.