Calantha Flooring July 21st, 2017 - 03:07:34
With reclaimed material waste factor is a huge variable. How much effort does the manufacturer take to give you a 100% usable product? Poorly milled with very little defecting and culling done on a solid wood floor that costs $6/sf and has a 15% waste factor actually costs more than a similar product that is milled better costing $7/sf with a 2% waste factor. That extra wastes costs more in shipping and labor to defect. This is one of the hardest things to demonstrate to a customer that the face value costs doesn`t necessarily represent the actual raw material cost unless one is truly comparing identical quality and specified products.
Traditional floor tiles can be difficult to replace as well. If one tile is damaged, in most cases all the tiles around it have to be replaced in the repair process. This is a costly and time consuming procedure. If one of the interlocking floor tiles is damaged, it is easy to pull the damaged tile up and replace it quickly. The repair time on broken interlocking tiles would take seconds, as opposed to the hours it would take to replace traditional tiles.
Another good flooring for wet areas is the vinyl tile. Typically it is manufactured in much the same way as sheet vinyl, but is much more rigid and comes as 12"x12" square units. They are installed in the much the same way, but require skilled tradesmen, familiar with proper installation. A good installer will start from the middle of the room to ensure that all cut tiles are equal in width at opposing walls. One advantage to this type of flooring, over sheet vinyl, is that it is can be installed, without danger of joint separation, over large areas. For this reason, it is often used in commercial buildings where large rooms are the norm. Vinyl tile can also be easily installed directly to concrete floors. Like vinyl sheets, it too is resistant to water, and tends to be installed in the areas of a building, prone to water accumulations. Tile, can be easily cleaned, is relatively maintenance free, and one of the cheaper finished floors to install.
Undoubtedly you`ve seen wood floors where it seems that the edges or seams of boards joined together curl up or the width of a board creates a bow like upward arc in the middle. These are indications of moisture damage to a wooden floor. For example, there have even been instances where moisture damage caused floor boards to arc together to raise a full length sofa about three feet into the air. That was merely from the curl effect and strength of water on wooden floor boards. So, by all means do dry any spills to keep moisture and liquids away from your wooden floors.