Orlene Flooring July 19th, 2017 - 21:10:56
Did you see a picture that you like and now you have the bug that you want that special floor? The good news is that it could probably be made for you, but before you go a long ways down the path of choosing which floor you want and requesting a display room full of samples, ask about some price ranges. There is a common misconception that since reclaimed wood is supposedly salvaged it should be cheaper than virgin wood floors. If you are buying a quality kiln dried and precision milled product, generally that is not the case. The only cost savings would be if you found some scraps or did some salvage work yourself, you might save some costs. For example you might find a gym floor or planks out of a barn hay loft that you want to nail down on your floor. The material might have been next to free, but how much time are you going to have in making it usable and pulling nails? Are the results what you want?
Traditional floor tiles can be difficult to replace as well. If one tile is damaged, in most cases all the tiles around it have to be replaced in the repair process. This is a costly and time consuming procedure. If one of the interlocking floor tiles is damaged, it is easy to pull the damaged tile up and replace it quickly. The repair time on broken interlocking tiles would take seconds, as opposed to the hours it would take to replace traditional tiles.
Ceramic tile is probably the most durable types of flooring and is typically installed in entry areas, where sand scuffing and water accumulations are the norm. Bathrooms and kitchens often get this type of floor treatment as well, but due to the high cost of installation, homeowners tend to not include these areas. Ceramic tile are typically a square tile, although interlocking units are on the market, in standard square measurements of 4", 6",8" or 12". They are installed by one of two primary methods, either set into a thin mortar bed (called "thinset adhesive"), which also acts like glue, or a heavyset bed of 1-1/2" normal mortar base. For all ceramic tile installations, the floor must be built up to ensure the strength required to prevent tile or joint cracking. Often, installers put down a material called "cement board", which is much like drywall, but is made of glass fibers and cement. In any case, ensure that your installer will offer you a guarantee against future cracking or uplift of tiles. Ceramic tiles require little maintenance, but beware, water on glossy floor tiles can be very slippery, and many a time, a homeowner has resented the installation of a high gloss tile, over a bathroom floor area.
Are you going to be able to enforce the warranty? Also, do you really think that a finish can last a lifetime? For example take a nail and try scraping it across the surface. Sure it is a durable, well applied finish, but it is impossible to make a product that won`t get abused at some point in its lifetime. Do you think that the only serious trial your floor will ever see is a stinky sock? Read the fine print on the warranty and regardless of what it says consider the true replacement cost on the floor. It probably only covers the cost of material of the specific damaged product under normal wear and tear. Your product may not be made exactly the same later (trends and product lines change) to replace the section that is warrantied, so you may have to replace the whole floor years later. You will have labor cost along with displacement of trim, cabinets, and appliances. Also most of these lifetime finishes cannot be repaired or sanded because of a micro bevel put on the edge of prefinished floor. Our advice is instead to buy a quality product that can be refinished and repaired because something will go wrong in the lifetime of the floor; don`t get a false sense of security.