Belda Flooring July 12th, 2017 - 19:46:58
Another way to prevent undue and excessive wear on your hardwood floors or wooden floors is to use scatter or throw rugs in high traffic areas. You may even be tempted to use a center rug piece for decor. Now that you and I have gotten past the fun stair rail slide and onto the floor, it is utterly important that we stay clear of injury -- Ensure that your throw, scatter or centerpiece rug either has sufficient non-skid backing or that you lay a non-slip material between it and your wood floor.
This shrinking action pulls the floor together, adding strength to the overall system. The advantages of this type of sub-floor are its strength and durability. One important note, homeowners are often disturbed by the small 1/4" wide gaps, generally left between the individual planks after the wood dries out. Although disturbing to see during construction, upon completion, the spaces are not noticeable, and really have no impact on the sub-floor components at all. Strip floors are designed to be interlocking, through lapping or spacing of joints.
Another good flooring for wet areas is the vinyl tile. Typically it is manufactured in much the same way as sheet vinyl, but is much more rigid and comes as 12"x12" square units. They are installed in the much the same way, but require skilled tradesmen, familiar with proper installation. A good installer will start from the middle of the room to ensure that all cut tiles are equal in width at opposing walls. One advantage to this type of flooring, over sheet vinyl, is that it is can be installed, without danger of joint separation, over large areas. For this reason, it is often used in commercial buildings where large rooms are the norm. Vinyl tile can also be easily installed directly to concrete floors. Like vinyl sheets, it too is resistant to water, and tends to be installed in the areas of a building, prone to water accumulations. Tile, can be easily cleaned, is relatively maintenance free, and one of the cheaper finished floors to install.
Of all, the most commonly installed flooring system are framed floors. They consist of dimensioned lumber, bearing on exterior and interior load bearing walls or beams called "floor joists". Generally the floor joists are installed, spaced 16" apart. Installing rim and trimmer joists, to which the floor joists are nailed, finishes the perimeter. Bracing, usually in the form of bridging, but often installed as strapping, prevents the joists from turning in place. One other method used to prevent this type of turning is to glue the sub-flooring to the joists, as the sub-floor is placed.