Lundy Flooring July 30th, 2017 - 19:55:34
Dust, grit and moisture are gifts of nature and we all have to deal with them. Grit which stems from sand or dirt being tracked from the outdoors on the surface works like sandpaper on the floor finish. Dust mites, balls and the like are merely pulverized bits of dirt which in essence acts in the same way as grit over the long haul on your floors. Once your floor finish gets damaged grit and dust left on the surface tend to discolor the hardwood while being ground into the surface pores with each step made on top of it like a hammer pounding stroke after stroke.
However if you go for a quality engineered wood flooring you can even gone as far as to boil a piece of our floor for 30 minutes and the board still will not de-laminate. The 15mm ply wood under core is what gives the flooring the strength and stability is has. Oak is a natural product and when used for flooring the board widths can change in size. This can cause gaps between boards or the floor to buckle and this movement is most commonly caused by the changing of humidity in the environment. Because of the stability of a quality engineered oak floor it is far less prone to this movement. This stability is also becoming of greater importance today due to the fact that an increasing number of properties are having under floor heating systems installed, which of course causes a frequent change in humidity. Having said this I would again like to reiterate that I am writing in regards to a quality, higher spec engineered oak flooring, and I can not talk for all engineered wood floors.
Interlocking floor tiles are also useful to those who might only want to make a temporary change to their floors. Traditional tiles require adhesive and caulking, which frequently results in damage to the underlying floor. Interlocking tiles do not usually require any adhesive at all and can be pulled up as needed. This allows for more versatility should the user decide to change their floor back or install a different set of interlocking floor tiles.
Fourth, factor in the cost of refinishing the floor later or doing touchups. This is a whole another article. Some finishes can be spot touched up like some of the oils while others require a full sand over the whole floor. Some finishes require a professional installer and may have extreme odor during the cure. If you live with the floor for very long, factor these decisions in for the type of finish to choose for lifetime durability and the cost & effort to refinish.