Nynette Flooring July 28th, 2017 - 17:08:07
One drawback is that this type of floor requires special hanger systems designed for the joists, to enable them to be hung from each other or against beams/bearing walls. Manufactured joists are becoming a popular flooring system, for they are relatively cheap, reduce labour time and provide adequate support. However, builders need to familiarize themselves with its installations, for poor installation can cause severe structural damage to the joists. A good example is a three point, center bearing joist, left with the top chord uncut, which can potentially fail or pull apart, over the center bearing point.
However if you go for a quality engineered wood flooring you can even gone as far as to boil a piece of our floor for 30 minutes and the board still will not de-laminate. The 15mm ply wood under core is what gives the flooring the strength and stability is has. Oak is a natural product and when used for flooring the board widths can change in size. This can cause gaps between boards or the floor to buckle and this movement is most commonly caused by the changing of humidity in the environment. Because of the stability of a quality engineered oak floor it is far less prone to this movement. This stability is also becoming of greater importance today due to the fact that an increasing number of properties are having under floor heating systems installed, which of course causes a frequent change in humidity. Having said this I would again like to reiterate that I am writing in regards to a quality, higher spec engineered oak flooring, and I can not talk for all engineered wood floors.
The third variable is installation costs. Our engineered product has labor savings over our solid wood product because it is pre-sanded and milled to tighter tolerances. It is also prefilled in the holes and has next to zero waste. On the other hand you may have a little more in cost of gluing it down in addition to nails, but this is just a step in direction of better quality and peace of mind during the install.
When it comes to price, interlocking floor tiles are significantly less expensive than standard tiles. The need for additional flooring or plywood, adhesive, tools and man hours can make standard floor tiles thousands of dollars more expensive than interlocking floor tiles. Interlocking floor tiles require very few tools and in most cases, can be placed directly on the floor and hammered in with a rubber mallet. They are also much easier to install without the assistance of a professional. This eliminates the need to hire expensive contractors to do the work. People who choose interlocking floor tiles can expect to save anywhere from $500 to $5000 depending on the area being tiled and the expense of the tile chosen. For a percentage of the traditional tile cost, those who choose interlocking tiles receive the same quality floor or better.