Nynette Flooring August 13th, 2017 - 19:38:44
When it comes to price, interlocking floor tiles are significantly less expensive than standard tiles. The need for additional flooring or plywood, adhesive, tools and man hours can make standard floor tiles thousands of dollars more expensive than interlocking floor tiles. Interlocking floor tiles require very few tools and in most cases, can be placed directly on the floor and hammered in with a rubber mallet. They are also much easier to install without the assistance of a professional. This eliminates the need to hire expensive contractors to do the work. People who choose interlocking floor tiles can expect to save anywhere from $500 to $5000 depending on the area being tiled and the expense of the tile chosen. For a percentage of the traditional tile cost, those who choose interlocking tiles receive the same quality floor or better.
Undoubtedly you`ve seen wood floors where it seems that the edges or seams of boards joined together curl up or the width of a board creates a bow like upward arc in the middle. These are indications of moisture damage to a wooden floor. For example, there have even been instances where moisture damage caused floor boards to arc together to raise a full length sofa about three feet into the air. That was merely from the curl effect and strength of water on wooden floor boards. So, by all means do dry any spills to keep moisture and liquids away from your wooden floors.
Truss floors are simply that. They are constructed from small dimensioned lumber, interconnected in a webwork pattern by the use of metal or wood plates. Occasionally, the trusses will be built on site, utilizing plywood plates to connect the webwork together. Generally they are installed 24" apart, either suspended on bearing walls or beams, or installed with plywood trim or rim joists around the perimeter. Strapping is installed on the bottom side, to prevent turning in place, which is a common ailment for deep truss components.
For the second variable here is a controversial opinion: we do not end match our flooring which means there is no tongue and groove on the ends of the planks. Since we recommend our floor be glued down we say this is an unnecessary expense for the customer. End matching reduces the yield in production and raises labor costs. Most end match profiles are milled so loosely that they really don`t hold the floor in place anyway. The biggest benefit to the installer is that the plank can be cut in half in any place and reused anywhere without have to mate up to a complementary tongue or groove since the end is just square cut. This means all end trim pieces or any waste can be reused. Therefore on our engineered flooring product the waste factor is virtually nothing unless there are angles or radiuses to work around. We also help with waste factor by usually supplying a random width product so when one gets close to the end of a room they can plan the width combination patterns out to not have to rip much off the last row.