Solaina Flooring July 23rd, 2017 - 20:39:00
Strip floors, were once the most popular type of sub-floor installed. But with the introduction of manufactured sheathing products, it has become less utilized. Strip floors consist of 1" by 6" or 8" boards, placed diagonally over the floor joist framing system. It is slightly more expensive to install, and requires experienced tradesmen. To install such floors properly, the lumber should be non-kiln dried, with a relatively high moisture content. This may seem odd, but in reality, as the wood dries out, it will shrink.
Some think of interlocking tiles and immediately think of ugly, heavy, rubber flooring used in the industrial sector. This could not be further from the truth. While interlocking tiles were initially created to serve the industrial sector, they have come a long way since that time. Interlocking floor tiles are now available in an array of finishes and material types. They can be purchased in rubber, plastic, vinyl and porcelain, among many other high quality materials. Virtually any tile material that can be used in a traditional installation can also be used in interlocking floor tiles.
So, a top quality oak engineered flooring will look the same but will it actually last as long?. How long a floor will last is mostly down to something called its `wear layer`. The part of the floor that is classed as the wear layer is from the surface of the board down to the tongue and on a solid oak board this would be around 5-6mm. Now, the wear layer on engineered wood flooring is the top layer of oak. So if you purchase an engineered oak flooring which has a 5-6mm solid oak top layer it will result in the flooring lasting just as long. In conclusion if you want an engineered flooring that is going to last as long as a traditional solid oak floor then make sure it has a nice thick top layer of wood, ideally 5mm+.
Laying the floor is also another area that is worth thinking about when comparing the two types of oak flooring. The majority of engineered wood floors are longer and wider than most solid oak boards because this is the look that most people are wanting nowadays. The flooring being longer and wider means the flooring is quicker to fit. Another aspect that makes this floor easier and quicker to fit is how well machined the boards are. From our experience in the flooring industry we have had nothing but good feedback regarding how easy our engineered flooring was to lay, and this is down to how well machined the boards are. Given that engineered flooring is quicker and easier to fit, any extra money that is spent on purchasing an engineered oak floor is often compensated in the time that is saved fitting it! This is something to keep in mind when comparing prices.