Nanine Flooring July 30th, 2017 - 17:56:12
Of all the wood flooring, the most often installed is the parquet tile. They consist of square interlocking wood strips, held together with glues and/or metal wires. Often they come as single 6"x6", or multiple 12"x12" square tiles, about 1/4" thick. They are glued directly to the sub-flooring, and are strong enough to span small deviations in it. The wood is often prefinished, and requires little maintenance. Parquet floors are a cheaper alternative to strip flooring, providing the same warm, durable surface.
Undoubtedly you`ve seen wood floors where it seems that the edges or seams of boards joined together curl up or the width of a board creates a bow like upward arc in the middle. These are indications of moisture damage to a wooden floor. For example, there have even been instances where moisture damage caused floor boards to arc together to raise a full length sofa about three feet into the air. That was merely from the curl effect and strength of water on wooden floor boards. So, by all means do dry any spills to keep moisture and liquids away from your wooden floors.
Interlocking floor tiles are also useful to those who might only want to make a temporary change to their floors. Traditional tiles require adhesive and caulking, which frequently results in damage to the underlying floor. Interlocking tiles do not usually require any adhesive at all and can be pulled up as needed. This allows for more versatility should the user decide to change their floor back or install a different set of interlocking floor tiles.
Truss floors are simply that. They are constructed from small dimensioned lumber, interconnected in a webwork pattern by the use of metal or wood plates. Occasionally, the trusses will be built on site, utilizing plywood plates to connect the webwork together. Generally they are installed 24" apart, either suspended on bearing walls or beams, or installed with plywood trim or rim joists around the perimeter. Strapping is installed on the bottom side, to prevent turning in place, which is a common ailment for deep truss components.