Orlene Flooring July 24th, 2017 - 22:01:09
Wood strip flooring is one of the oldest types of flooring still popular in the modern age. It consists of wood strips, usually interlocking, which are either nailed or glued to the sub-floor. Often the strips will be prefinished, requiring no post applications of sealers or varnishes. This type of flooring is very labour intensive for installation, as well as being quite expensive to purchase. However, the results are a warm, durable floor surface, requiring little maintenance or upkeep. Wood strip flooring significantly adds to the strength of the support system, reducing the deflection ("bounce") and gives the floor a very solid feel to it.
In this article we will be discussing several different categories of wood flooring. Solid wood flooring is one board with no glued up laminations; it is basically wood board that has been sized and profiled to a certain dimension. Engineered flooring has a on the top whatever species and texture you want, and this is glued to a plywood backer on the bottom. Engineered is still all wood but is made with multiple layers that are laminated for better stability and dimensional accuracy. Floors that we will not cover here are laminates or any composite products which are often not wood entirely through the plank or may be made with a photo printed surface. We also will not cover vinyl, carpet, stone, or tile.
Strip floors, were once the most popular type of sub-floor installed. But with the introduction of manufactured sheathing products, it has become less utilized. Strip floors consist of 1" by 6" or 8" boards, placed diagonally over the floor joist framing system. It is slightly more expensive to install, and requires experienced tradesmen. To install such floors properly, the lumber should be non-kiln dried, with a relatively high moisture content. This may seem odd, but in reality, as the wood dries out, it will shrink.
However if you go for a quality engineered wood flooring you can even gone as far as to boil a piece of our floor for 30 minutes and the board still will not de-laminate. The 15mm ply wood under core is what gives the flooring the strength and stability is has. Oak is a natural product and when used for flooring the board widths can change in size. This can cause gaps between boards or the floor to buckle and this movement is most commonly caused by the changing of humidity in the environment. Because of the stability of a quality engineered oak floor it is far less prone to this movement. This stability is also becoming of greater importance today due to the fact that an increasing number of properties are having under floor heating systems installed, which of course causes a frequent change in humidity. Having said this I would again like to reiterate that I am writing in regards to a quality, higher spec engineered oak flooring, and I can not talk for all engineered wood floors.