Nynette Flooring August 07th, 2017 - 18:43:54
In this article we will be discussing several different categories of wood flooring. Solid wood flooring is one board with no glued up laminations; it is basically wood board that has been sized and profiled to a certain dimension. Engineered flooring has a on the top whatever species and texture you want, and this is glued to a plywood backer on the bottom. Engineered is still all wood but is made with multiple layers that are laminated for better stability and dimensional accuracy. Floors that we will not cover here are laminates or any composite products which are often not wood entirely through the plank or may be made with a photo printed surface. We also will not cover vinyl, carpet, stone, or tile.
Undoubtedly you`ve seen wood floors where it seems that the edges or seams of boards joined together curl up or the width of a board creates a bow like upward arc in the middle. These are indications of moisture damage to a wooden floor. For example, there have even been instances where moisture damage caused floor boards to arc together to raise a full length sofa about three feet into the air. That was merely from the curl effect and strength of water on wooden floor boards. So, by all means do dry any spills to keep moisture and liquids away from your wooden floors.
Raw sheathing comes in 4`x8` sheets, most often installed as 3/4" thick plywood panels. This type of sheathing is adequate for spanning joist work spaced up to 24" apart. The sheathing is lain with the joints staggered in such a matter, that no two edge joints line up with adjoining sheets. It is very easy to install, requiring the least amount of labour. The sheets are fastened with either 1-1/2" flooring screws, or 2-1/2" nails, spaced about 8" apart. Although not required, it is a good idea to provide backers or supports under the joints, between sheets which run perpendicular to the framed floor assembly.
Truss floors are simply that. They are constructed from small dimensioned lumber, interconnected in a webwork pattern by the use of metal or wood plates. Occasionally, the trusses will be built on site, utilizing plywood plates to connect the webwork together. Generally they are installed 24" apart, either suspended on bearing walls or beams, or installed with plywood trim or rim joists around the perimeter. Strapping is installed on the bottom side, to prevent turning in place, which is a common ailment for deep truss components.