Aveline Flooring July 15th, 2017 - 18:52:11
There are three main types of sub-flooring installed to cover and span the floor structure. It is over this that the finished floor will be placed. The sub-flooring types include raw sheathing, interlocking and strip. It is utilized not only to provide a surface for the interior finishes to be placed on, but also to prevent twisting or torque forces placed on the building. The sub-floor also allows load sharing within the joist framing system. Often the sub-flooring is glued to the joist work to eliminate creaking floors and to prevent the floor joists from turning.
We personally do not care for prefinished flooring due to installation problems associated with it, so our product requires site applied finish. This means that your floor finish if site applied will be easier to sand and refinish than a prefinished floor. Also you do not have to deal with that micro bevel groove between each board that tends to fill up with dust and crumbs. Most prefinished hardwood floors really can`t be refinished easily. To sand it off means that the wear layer has to be thicker than the height of the nails and have room to sand off the micro bevel between boards; that amounts to a lot of sanding. You also will not be able to spot sand or touch up parts of the floor.
Another good flooring for wet areas is the vinyl tile. Typically it is manufactured in much the same way as sheet vinyl, but is much more rigid and comes as 12"x12" square units. They are installed in the much the same way, but require skilled tradesmen, familiar with proper installation. A good installer will start from the middle of the room to ensure that all cut tiles are equal in width at opposing walls. One advantage to this type of flooring, over sheet vinyl, is that it is can be installed, without danger of joint separation, over large areas. For this reason, it is often used in commercial buildings where large rooms are the norm. Vinyl tile can also be easily installed directly to concrete floors. Like vinyl sheets, it too is resistant to water, and tends to be installed in the areas of a building, prone to water accumulations. Tile, can be easily cleaned, is relatively maintenance free, and one of the cheaper finished floors to install.
In a reclaimed product the engineered flooring really shines. Since the nature of reclaimed material is rustic with splits, various height, warps and so forth by doing an engineered product we can eliminate those issues. We match the texture and color that you want in the floor but you don`t have to put up with the inherent problems that come with installing and living with a reclaimed wood floor. A number of solid wood reclaimed floors have warped and twisted boards, gaps between rows, height difference between rows, holes, and other "nostalgia and romance" that may become unwelcome after living with the floor for a while. Due to our precise sanding during the lamination process for the engineered product and after, pieces are more consistent in height, more uniform in texture, fit together tighter, no waste, holes and cracks already filled, and no sanding necessary after install unless you want to do a light screen or buff.